Table of Contents
Advertisement
11
Reset the ink counter in the following procedure.
ATTENTION
Be sure to reset the ink counter after replacing the
print cartridge.
1
Display the [Software Operation Panel] window.
Windows Server 2008/Windows 7
Click [Start] menu [All Programs] [fi Series]
[Software Operation Panel].
Windows Server 2012
Right-click the Start screen, and select [All apps] on
the app bar [Software Operation Panel] under [fi
Series].
Windows Server 2012 R2/Windows 8.1
Click [] on the lower left side of the Start screen and
select [Software Operation Panel] under [fi Series].
To display [], move the mouse cursor.
Windows 10/Windows Server 2016
Click [Start] menu [fi Series] [Software
Operation Panel].
2
Click [Device Setting] from the list on the left, and
then click the [Clear] button of [Remaining Ink].
The value of the counter is set to 100.
3
Click the [OK] button on the [Software Operation
Panel] window.
4
A message appears. Click the [OK] button.
The [Software Operation Panel] window closes,
and the ink counter is cleared.
3.5 Removing Jammed Documents
If a document jams, remove the jammed document as
follows:
ATTENTION
Open the ADF and the print section to remove the
jammed document. Do not pull out the document
forcefully.
1
Remove the documents from the ADF paper chute
(feeder).
2
Hold the middle part of the print section, and open it
as shown in the figure.
ATTENTION
When you open the ADF, be sure to open the print
section beforehand.
3
Open the ADF.
ADF
Print
Section
4
Remove the jammed document.
16
Advertisement
Table of Contents
