Installation; Unpacking; Pack List; Installing Your Stove - HearthStone Green Mountain 40 Owner's Manual

I
NSTALLATION
U
NPACKING
Hearthstone packages your Green Mountain 40
woodstove with the greatest care so that it ships
safely. Under certain circumstances, however,
damage may occur during transit and handling.
When you receive the Green Mountain 40, carefully
unpack and inspect the stove and all accompanying
parts. Ensure that all parts are included inside the
stove. If any parts are damaged or missing, please
contact your authorized
immediately.
P L
ACK IST
Green Mountain 40 Model 8640 Woodstove
Owner's Manual
The label is attached by a cable to the bottom of the
stove. Take care when lifting the stove not to
damage the label or cable. After final positioning of
the stove, the label may be stored in the holding clip
on the bottom shield of the stove.
Figure 2 - Label Location
Hearthstone Quality Home Heating Products, Inc ®
Hearthstone dealer
I Y
NSTALLING OUR
Choose a place to install your Green Mountain 40
woodstove. Consider the location of your stove for
optimum heating efficiency. In general, it is better to
place your stove in a main living area, rather than in
a basement or other confined space.
Inspect this location to make sure that the stove and
stovepipes will have the required clearance from
combustible materials that are near the stove.
Combustibles include walls, floor, ceiling, and
chimney chase. You must carefully consider the
clearances to all of these combustibles before
actually connecting your stove.
If the floor is made of combustible material, then a
non-combustible floor protector is required between
the floor and the stove. An example of a non-
combustible floor protector is a hearth constructed
with a continuous layer of tile, brick, slate, glass or
another non-combustible facing. There is no R-value
requirement.
If you use a rear connector pipe, ensure it is listed
with Underwriter's Laboratories. Check the listing of
your pipe with UL for the correct clearances.
The diagrams in this manual represent typical
installations, but are specific to the Simpson Dura-
Vent DVL brand.
Clearances to NFPA
Surfaces
You can reduce the clearances to combustible
surfaces by using any National Fire Protection
Agency (NFPA) approved wall protection system
with additional approval of the regulatory authority
having jurisdiction in your area. Please refer to
NFPA Code 211 for specifications and complete
details. You can obtain this information directly from
the NFPA.
National Fire Protection Agency
Batterymarch Park
Quincy, MA 02269
1-800-344-3555
1-617-770-3000
www.nfpa.org
7
S
TOVE
Code 211 Protected
Green Mountain 40 (Model 8640)