Basic Installation Instructions; Proper Location - 2N ATEUS 501106E User Manual

2. Basic Installation Instructions

This chapter describes the basic connection of the GSM Gateway that can be made in a few
minutes. All you have to do is to connect an antenna, the power supply cable and telephone
lines, insert your SIM card and the GSM Gateway is ready to work.

2.1. Proper Location

• The ATEUS
® - DIAL-THRU GSM GATEWAY is a transmitter in principle. You must comply
with the local regulations and laws in your country pertinent to usage of mobile phones and
transmitters!
• The ATEUS
®
- DIAL-THRU GSM GATEWAY is designed for vertical mounting. For the
required working position see Fig.1.
• The GSM Gateway may be operated in a position other than vertical (on a desk, e.g.) for a
short time only – for quick maintenance testing, for example.
• For the acceptable range of operating temperature and humidity refer to the "Technical
Parameters".
• The GSM Gateway may not be operated at places
exposed to direct solar or heat radiation.
• Exceeding the acceptable operating temperature does
not have an immediate impact on the GSM Gateway
function, but may result in accelerated ageing (of
batteries in particular!) and lower reliability.
• The GSM Gateway is designed for indoor use. It must
not be exposed to rain, water, condensed moisture, fog,
etc.
• The GSM Gateway must not be exposed to corrosive
gas, fumes of acids or solvents, etc., or corrosive liquids,
during cover cleaning, for example.
• The GSM Gateway is not intended for use in high-
vibration locations such as means of transport, machine
rooms, etc.
• The GSM Gateway should be located with respect to the
GSM signal quality.
• A free space should be left over and under the GSM
Gateway for cables and flowing air that removes heat
produced during the operation.
Fig. 1.: GSM Gateway Working Position
8