Quantum Scalar i500 Getting Started Manual page 6

Step 1: Unpack the Library
1 Unpack the library.
Following the unpacking instructions that came with the library, remove the library exterior packaging
but leave the library in the bottom packaging tray.
Save all packing materials in case you need to move or ship the
CAUTION
library in the future.
2 Check the contents of the package against the packing slip.
3 Remove the interior packaging.
Be sure to remove the following items:
CAUTION
• The strap holding the robot in place. Release the velcro and unhook
• All cardboard and foam surrounding the robot.
WITHOUT TAPE DRIVES, TAPE CARTRIDGES, OR POWER
WARNING
SUPPLIES, A 5U CONTROL MODULE WEIGHS APPROXIMATELY 58
LBS. A 9U EXPANSION MODULE, WITHOUT TAPE DRIVES, TAPE
CARTRIDGES, OR POWER SUPPLIES, EXCEEDS 65 LBS. TO AVOID
SERIOUS INJURY, TWO PEOPLE ARE REQUIRED TO SAFELY LIFT
THE MODULES INTO POSITION.
4 Remove the tape drives from the library.
For information about removing tape drives, see "Adding, Removing, and Replacing" in the Scalar i500
User's Guide.
5 Remove the power supplies from the library.
For information about removing power supplies, see "Adding, Removing, and Replacing" in the Scalar
i500 User's Guide.
6 Choose an optimal location for the library.
To avoid damage, the library must be positioned in a stable location. See the System, Safety, and
Regulatory Information Guide for more information on finding an optimal location for your library.
THE POWER OUTLET MUST BE AVAILABLE NEAR THE LIBRARY
WARNING
AND MUST BE EASILY ACCESSIBLE.
• Make sure a power source (only of the type marked on the product label) is available. For power
requirements, see the "Specifications" chapter in the Scalar i500 User's Guide.
• Route any cables to avoid walking on them or pinching them with items placed on or against them.
Pay particular attention to the cord at the wall receptacle and the point where the cord exits from
the library. For recommended cabling procedures, see the Scalar i500 User's Guide.
• Make sure that objects will not fall and liquids will not spill into the library's chassis through
openings.
6
each end of the strap.
Scalar i500 Getting Started Guide