Page 1
Once the product has been installed this manual Tel : +61 2 6280 6476 must be given to the owner/ operator of this equipment. Waterco Limited ABN 62 002 070 733 www.waterco.com (W23421) 07/2008...
Page 2
I pg 01 Table of AQUABIOME Aquabiome has been engineered specifically for ponds and water gardens. Aquabiome provides mechanical and biological filtration in a single housing. Its ability to support dense populations of nitrifying bacteria, its reliability and easy maintenance, AQUABIOME ------------------------------------------------- 01 makes Aquabiome especially suitable for high density recirculation systems.
Page 3
Possibly reducing power use by 50%! matter. Perhaps most important of all, an Aquabiome will require far less maintenance – cleaning or back The second stage would be air supplied by a simple air pump and air stone, injecting the air directly washing than a typical Hi Rate pressure sand filter.
Page 4
5 minutes to perform. (See general running instructions). 52 - 101 80 - 157 120 - 226 180 – 353 255 - 509 The Aquabiome is designed to ensure servicing simplicity. The main filter body has a large 8” m3/hr 3.1 – 6.1 4.8 – 9.4 7.2 – 13.5 10.8 – 21.2 15.3 – 30.5 diameter lid for easy access to the internals of the filter.
Tighten the connections by hand only. 8. Screw on the return union to the remaining position (on the lower - RHS) of the Multi-port valve. Starting Up The Aquabiome Tighten the connection by hand only. 1. Re-check all threaded connections to ensure they are watertight and select ‘Filter’ mode on the 9.
I pg 09 Waterco Aquabiome Backwashing Procedure For The Aquabiome IMPORTANT NOTES: 1. Turn the circulating pump off. Never try to run the Blower and the circulating pump at the same time! 2. Select 3pm position on the isolator valve (handle in line with pipe).