ACS
Series
3.0
Installation
Brooder Assembly Instructions
Before assembling brooder, verify that all components are included. Refer to page 36 for a list of the kit
1
contents for your model heater. The hardware kit contains all nuts, bolts and washer required for
brooder assembly. Materials not included in the heater kit contents (e.g., gas cock, flex connector,
terminals, etc.) are the responsibility of the installer.
Open hanger kit.
2
Place the hanger onto the center of the reflector canopy using the 1/4"-20 x 5/8" bolt, 1/4" washer, and
3
1/4"-20 keps nut from the hanger kit and align it with the holes as shown in Figure 3.1.
Attach eye bolt to the hanger with 1/4"-20 keps nuts, 1/4" washers, and 1/4"-20 wing nut provided.
4
Place emitter cone assembly on a table with the emitter mounting studs facing upward and place
5
reflector canopy over emitter cone assembly so that the three studs on the bracket pass through the
three holes on the reflector canopy. Secure the reflector canopy and hanger to the mounting studs using
1/4"-20 keps nuts and washers provided.
Figure 3.1
•
Brooder Assembly
1/4"-20 Keps Nuts
5
(included in Hanger Kit)
1/4"-20 x 5/8" Bolt,
3
1/4-20 Keps Nut & Washer
(included in Hanger Kit)
& Washers
Hanger
3
BP-179
3.0
Installation
4
5
9
•
Brooder Assembly Instructions
Eyebolt with 1/4"-20 Keps
Nuts & Washers
(included in Hanger Kit)
Alignment Holes
3
Reflector Canopy
5
BP-88
Emitter Cone Assembly
BP-190