Fenix 45 Turbo User Manual page 12

•
When workpiece's temperature reaches to set temperature, demagnetisation will
start and you will see the screen below and the machine will generates an acoustic
warning signal for few seconds. The machine will be ready to new operation when
demagnetisation process ends.
•
Do not forget that, heated workpiece may cause injuries. Use proper handling
equipment to remove workpiece.
•
In the case, the magnet sensor not connected or damaged, you will see the
secreen below then it will turn to manin menu. Try to operate the machine after
checking the magnet sensor.
•
If damage on magnet sensor can not be fixed, operate the machine in Time Mode.
Do not forget that, heating bearing without checking its tempereture, can give
damage to bearing.
•
If the workpiece's temperature will not increase in 2 minutes, or sensor doesn't
located properly the machine will give "Probe Error !!!" message with acoustic
warning signal then will turn to main menu.
TEMP SENSOR
NOT CONNECTED!
12/16
FeniX Induction Heaters