Front Light Group - PIAGGIO Beverly Tourer 125 Manual

Front light group (03_28, 03_29, 03_30, 03_31, 03_32, 03_33,

03_34)
To remove the front headlight assembly, proceed as follows:
1. Remove the screws «A» of the brake fluid reservoir caps.
2. Remove the windshield by undoing the five screws «B».
3. Remove the rear-view mirrors.
4. Remove the screws «C» of the upper coupling.
03_28
5. Remove the screws «D» of the lower coupling.
6. Remove the two screws «E» of the rear handlebar cover.
7. Remove the front handlebar cover.
This gives access to the bulbs.
Release the clip and take out the bulb of the high/low-beam headlamp «F».
To replace the tail light «G», take out the rubber bulb holder from its fitting.
To reassemble, repeat the operation in the reverse order.
WARNING
03_29
THE TWIN-FILAMENT (HIGH-BEAM AND LOW-BEAM) BULB IS HALOGEN: DO
NOT TOUCH THE BULB WITH YOUR FINGERS TO AVOID COMPROMISING ITS
FUNCTIONING
03_30
65