Front Light Group - PIAGGIO LUM Beverly Sport Touring 350 ie Manual

Front light group (03_41, 03_42, 03_43, 03_44)

To remove the front headlight assembly the windshield does not need to be removed.
To remove the front headlight assembly, proceed as follows:
- Unscrew the two screws «A» and remove the pressure covering
- Unscrew the two upper screws «E» fastening the headlight assembly
- Working on both sides of the vehicle, unscrew the lower fixing screws «C» and re-
move the headlight. Remove the rubber protection.
This gives access to the bulbs.
03_41
To replace the low-beam light act on the lamp holder«D». To replace the high-beam
light act on the lamp holder«E» unhooking the relevant pin.
To reassemble, repeat the operation but in reverse order.
WARNING
HIGH- AND LOW-BEAM BULBS ARE HALOGEN TYPE: DO NOT TOUCH THEM
WITH YOUR FINGERS TO AVOID DAMAGING THEIR FUNCTION.
03_42
CAUTION
DO NOT PLACE, TRANSPORT OBJECTS AND/OR CLOTHES OVER THE FRONT
HEADLIGHT ASSEMBLY, WHEN THE HEADLIGHT IS TURNED ON OR OFF.
FAILURE TO FOLLOW THIS PRECAUTION MAY CAUSE OVERHEATING AND
THE SUBSEQUENT FUSION OF THE GLASS.
03_43
62