Table of Contents
Advertisement
M O UNTING INSTRU CTIO NS
Preparation of the stove for
rear discharge to a brick-built
chimney
Scan 60 and 61: we refer to the specific instructions for
these stoves.
Fig. 1 (1-4)
1. Remove the cover
plate on the rear of the
stove.
3. Remove the inner cover
plate (cooking ring) with the
hexagon spanner. The cook-
ing ring is to be put in the top
outlet (for models with a dou-
ble-steel top plate, you must
first mount an intermediary
ring). Remove the ceramic
gasket from the cooking ring
and place it in the top outlet
without fixing it).
Fig. 2
2. Cut free the inner
plate with a pair of nip-
pers
4. Fit the flue collar from
the outside into the dis-
charge hole of the com-
bustion chamber in such
a way that the bracket
is located on the inside.
Tighten the screws.
Scan
4
and
Scan
ANDERSEN stoves are
equipped with a heat
shield at the rear (Fig.
2). The rear outlet is
punched in the plates.
Remove the two punched
plates and continue on
fig. 1, ill. 3-4.
Top outlet and elbow
Fig. 3
You can also connect your stove with a top outlet and a 90-
degree elbow into the chimney.
The stove is prepared in the same way as a direct connec-
tion to a steel chimney (see page 6).
5
Hide quick links:
Advertisement
Table of Contents
