Resetting Lock To Factory Default - Yale Nest x Lock Programming, Troubleshooting Manual

Resetting Lock to Factory Default

When lock is reset to factory defaults, all
user codes (including the Master Passcode*)
are deleted and all programming features are
reset to original default settings (see below).
1. Remove the battery cover and batteries.
2. Remove the inside of lock to access the
reset button.
3. The reset button (see image at right) is
located on left side of
connector.
4. While pressing the reset button (minimum
of 3 seconds) reinstall batteries. Release
reset button. Lock responds with "Hi
from Yale and Nest".
5. Replace battery cover.
*The Master Passcode must be registered prior to any other programming of the lock.
NOTE TO INSTALLER AND CONSUMER
®
While Yale has included several features to prevent lockout (9-Volt battery jumper, low battery
warnings), it is still possible for a lockout situation to occur. Because this product does not have
a mechanical override (a key), Yale recommends to use this product in an environment where
there are additional entry points into the dwelling.
PCB cable
®
P/N YRD
Reset
Button
Inside of Lock
9
540WV Rev 1