Selecting The Video Signal Type - JVC CA-EXAK2D Instructions Manual

Connecting up (continued)
13
Selecting the video
signal type
To view an image on the TV screen, select the
video signal type correctly according to the TV
after connecting the main unit to the TV.
1
2
DVD/CD 3
3
2/3
/ENTER
4
5
NOTE
• To check the compatibility of your TV, contact your
local JVC customer service center.
• All JVC-manufactured progressive TVs and high-
definition TVs are fully compatible with this system.
• Even if the power cable of the main unit is
disconnected from the AC outlet or the power is
interrupted, the video signal type setting is stored.
Turn on the main unit.
• Refer to "Connecting the power cord" on
page 12 and "Playback" on page 14.
Press DVD/CD 3.
• When a disc is loaded, press
playback.
Hold down SCAN MODE.
• The current video signal type flashes.
Press 2 or 3 to select the video
signal type suitable for the TV.
• You can select "RGB", "Y/C" or
"PROGRESS".
• Select "RGB" when a TV compatible with
composite video signals is connected to the
AV terminal.
• Select "Y/C" when a TV compatible with S-
video signals is connected to the AV
terminal.
• Select "PROGRESS" when a TV
compatible with progressive scanning is
connected to the COMPONENT VIDEO
OUT terminals.
Press ENTER.
7
to stop