Selecting The Video Signal Type - JVC NX-F55 Instructions Manual

Preparation (continued)
Selecting the video signal
type
To view an image on the TV screen, select the
video signal type correctly according to the TV
after connecting the main unit to the TV.
■ IMPORTANT
• Slide the remote control mode
selector to [SHIFT].
1
Turn on the main unit.
• Refer to "Turning on/off the main unit" on
page 12.
2
Press [DVD ] or [USB
3
• When a disc is loaded or a USB device is
connected, press
7
3
Press [SCAN MODE].
• The current video signal type appears.
Example: When "576I (Interlace)" is
selected as the video signal
11
Remote control
mode selector
/ (cursor)/
2 3
ENTER
].
3
to stop playback.
4
Press or (cursor) to select the
2 3
video signal type suitable for the
TV.
• When the TV is connected to the [VIDEO]
terminal, select "576I".
• When the TV is connected to the
[COMPONENT] terminals, select "576P".
• When the TV is connected to the [HDMI
MONITOR OUT] terminal, the video signal
type can be selected as instructed below.
- Select "AUTO" for normal usage. (initial
setting)
- Select "576P", "720P", "1080I" or "1080P"
as needed. (The selectable settings differ
according to the resolution of the
connected TV.)
• You can also select the video signal type by
repeatedly pressing [SCAN MODE].
NOTE
• "576", "720" and "1080" refer to the number of
the scanning lines. Generally, the larger the
number, the better picture that can be obtained.
• "I" refers to the interlaced scanning. "P" refers to
the progressive scanning. A better picture can
be obtained in the progressive scanning than in
the interlaced scanning.
• When an HDMI video signal is output, the
"HDMI" indicator lights up in the display window.
• When an HD video signal is output, the "HD"
indicator lights up.
• When "576P", "720P" or "1080P" is selected, the
"PROGRESSIVE" indicator lights up in the
display window.
5
Press [ENTER].
NOTE
• It is recommended that you slide the remote
control mode selector to [AUDIO] after selecting
the video signal type. Most of the other functions
can be used when the remote control mode
selector is at [AUDIO].
• Even if the main unit is turned off, the video
signal type setting is stored.