Connecting With Tv; Connecting The Power Cord - JVC CA-EXAK2D Instructions Manual

CAUTION
• For details of signals to be output, refer to page
36.
• If the main unit is connected to equipment with
a Dolby Digital decoder, the "D. RANGE
COMPRESSION" setting of "AUDIO"
(A page 36) is disabled for sound from the
digital audio output of the main unit.
• You can output the audio signal from the
DIGITAL OUT terminal when a loaded disc is
selected as the source.
• Pressing SURROUND MODE while the audio
signal is being output from the DIGITAL OUT
terminal may cause intermittent sound output.

Connecting with TV

Connecting a TV with the AV terminal
TV
To SCART connector
SCART cable (sold separately)
NOTE
• No audio signal is output via AV (SCART) terminal.
CAUTION
Connect the main unit directly with a TV (or a
monitor) without routing through a VCR.
Otherwise it may cause picture distortion while
playing.
Main unit
Connecting directly
Also, when connecting the main unit to a TV with
a VCR built in, there may be picture distortion
while playing.
Connecting a TV with the COMPONENT
VIDEO OUT terminals

Connecting the power cord

Main unit
• Connect the power cord after all other
connections are complete.
• The STANDBY lamp (on the front panel) will be
lit.
TV (or
monitor)
Getting started
TV
To component
terminals
Component video cable (not supplied)
AC outlet
Supplied power cord
Main Unit
(rear view)
Main unit
12