Safety Warnings - Sullair 3000PB User Manual

1: Safety
lockout hasps on power shall remove pad-
lock and lockout hasps and restore power.
However, when the authorized person who
applied the lock is unavailable to remove it
his/her Supervisor may remove padlock/pad-
locks and lockout hasps and restore power
only if it is first:
a. verified that no person will be exposed to
danger.
b. verified that the "Authorized" person who
applied the device is not in the facility.
c. noted that all reasonable efforts to con-
tact the "Authorized" person have been
made to inform him or her that the lock-
out or tagout device has been removed.
d. ensured that the "Authorized" person is
notified of lock removal before returning
to work.
2. Tagout System—Tags are warning devices
affixed at points of power disconnect and are
not to be removed by anyone other that the
person placing tag on power lockout. Tags
shall never be by-passed, ignored, or other-
wise defeated.

1.12 Safety warnings

The following special instructions apply to VSD packages
provided with electronic adjustable speed motor drives.
These cautions that apply to VSD operation.
6
3000PB, 3700B, 4500B, 3000PVB, 3700VB, 4500VB User Manual
02250216-786 R01
Subject to EAR, ECCN EAR99 and related export control restrictions.
WARNING
Ground the unit following the instructions in this
manual. Ungrounded units may cause electric
shock and/or fire. The variable speed drive has a
large capacitive leakage current during opera-
tion, which can cause enclosure parts to be
above ground potential. Proper grounding, as
described in this manual, is required. Failure to
observe this precaution could result in death or
severe injury.
WARNING
Before applying power to the variable speed
drive, make sure that the front and cable covers
are closed and fastened to prevent exposure to
potential electrical fault conditions. Failure to
observe this precaution could result in death or
severe injury.
WARNING
Refer all drive service to trained technicians.
This equipment should be installed, adjusted,
and serviced by qualified electrical maintenance
personnel familiar with the construction and
operation of this type of equipment and the haz-
ards involved and in accordance with published
service manuals. Failure to observe this precau-
tion could result in death or severe injury.
WARNING
Line terminals (L1, L2, L3), motor terminals (U,
V, W) and the DC link/brake resistor terminals (-/
+) are live when the drive is connected to power,
even if the motor is not running. Contact with
this voltage is extremely dangerous and may
cause death or severe injury.