Configuring The Kes Server To Use The Service Account To Access The Exchange Server - EMC IS1200 Configuration Manual

Chapter 2: Establishing Communications Between Exchange and IS1200
You can elect to run (install) the package, or save it. If you elect to install you may see
the warning on the right above. Click Run to run the installer, and follow the prompts
until you are notified the installation is complete.
Configuring the KES Server to Use the Service Account to
Access the Exchange Server
Once the KES server is setup and the ES Agent installed, the
should be active in IIS and must be configured to impersonate (the IS1200) using the
account
kazAdmin
described above in
page 9), do the following to setup impersonation:
Note: The user that does the following must be explicitly added to the KES Server
"Local Administrators" group. It is not sufficient for the user to be a member of
another group that is added to the "Local Administrators" group.
1. From the KES server, launch the IIS Manager
(Start>Administrative Tools>IIS Manager)
2. From the left pane, click to expand "(local)Computer", then "Web Sites", then
"Default Website", and then select
3. Right click
kazexchservice Properties dialog opens.
16
. Assuming
kazAdmin
"Creating the IS1200 Service Account on the AD Server" on
and select Properties. A
kazexchservice
EMC SourceOne eDiscovery - Kazeon IS1200 Microsoft Exchange Connector User Guide
kazexchservice
has already been setup in the AD server (as
.
kazexchservice