General Considerations - Honeywell S4565 Production Handbook

GENERAL CONSIDERATIONS

To ensure reliable long term operation, mount ignition control
at a position in the appliance with a low ambient temperature
and a low radiation.
The ignition control should be externally fused.
High temperatures will affect product life.
After installation wait at least 1 hour before connecting to
mains.
NOTE 22.: Electrical rating of connected controls and air
proving switch should be appropriate for the
load that is switched by the ignition control.
NOTE 23.: Power interruptions will cause program restart.
NOTE 24.: The flame connection pin of all types is protected
against electrical schock. The gas pressure
switch as mentioned in this instruction sheet is a
functional device.
NOTE 25.: If the ignition control incorporates an EMC filter,
disconnect the ignition controller from mains
before performing a dielectric strength test.
WARNING
Honeywell is not responsible for damage, injury due
to mis wiring.
After installation the ignition control can become wet
due to condensation.
Do not connect wet device to mains
59 EN2R-9031 0402R15-NE