Storage Drive In The Front-Access Storage Enclosure - Lenovo 30BY User Manual

c. If necessary, remove the plastic panel in the front bezel for the desired flex bay.
d. Slide the new optical drive into the flex bay from the front of the computer until the optical drive
snaps into position.
Figure 32. Installing the optical drive
e. Connect the cables to the rear of the new optical drive.
Figure 33. Connecting the cables to the rear of the new optical drive
5. Reinstall the front bezel. See "Front bezel" on page 63.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 108.

Storage drive in the front-access storage enclosure

Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page v.
The storage drive in the front-access storage drive can be hot-swappable. When both the following
requirements are met, you can remove or install the drive without even turning off your computer.
• The SATA cable of the front-access storage enclosure is connected to the eSATA connector on the
system board. To verify the cable connection, see "Preparing your computer and removing the computer
cover" on page 61 and "Parts on the system board" on page 6 for more information.
76
P520c User Guide