Storage Drive In The Front-Access Storage Enclosure - Lenovo ThinkStation P340 Hardware Maintenance Manual

Removal steps

Storage drive in the front-access storage enclosure

Prerequisite
Before you start, read Chapter 1 "Important safety information" on page 1 and print the following
instructions.
Attention: The internal storage drive is sensitive. Inappropriate handling might cause damage and
permanent loss of data. When handling the internal storage drive, observe the following guidelines:
• Replace the internal storage drive only for upgrade or repair. The internal storage drive is not designed for
frequent changes or replacement.
• Before replacing the internal storage drive, make a backup copy of all the data that you want to keep.
• Do not touch the contact edge of the internal storage drive. Otherwise, the internal storage drive might get
damaged.
• Do not apply pressure to the internal storage drive.
• Do not make the internal storage drive subject to physical shocks or vibration. Put the internal storage
drive on a soft material, such as cloth, to absorb physical shocks.
You can install or replace a storage drive in the front-access storage enclosure. The storage drive also can
be hot-swappable, which means that you can install or replace the drive without even turning off your
computer. Therefore, lock the enclosure cover to prevent the unexpected removal. The keys are attached at
the rear of the computer. Store the keys in a secure place.
The storage drive in the front-access storage enclosure is hot-swappable only when the following
requirements are met:
• The eSATA mode of the SATA 4 connector is enabled by doing the following:
1. Restart the computer. When the logo screen is displayed, press F1 or Fn+F1.
2. Select Devices ➙ ATA Drive Setup ➙ SATA Drive 4 Hot-Plug Support and press Enter.
3. Select Enabled and press Enter.
78
P340 Hardware Maintenance Manual