Lenovo 30BY User Manual page 115

1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 61.
2. Locate the secondary storage drive. See "Computer components" on page 5.
3. To remove the secondary storage drive, do the following:
a. Disconnect the signal cable and the power cable from the storage drive.
b. Pull the handle of the plastic 3.5-inch storage-drive bracket to remove the storage drive from the
storage drive bay.
Figure 81. Removing the secondary storage drive
c. Flex the sides of the bracket to remove the storage drive from the bracket.
4. To install the secondary storage drive, do the following:
a. Pull the handle of the plastic 3.5-inch storage-drive bracket to remove it from the storage drive bay.
b. To install a new storage drive into the bracket, flex the bracket and align pin
4 on the bracket with the corresponding holes in the storage drive. Do not touch the circuit board
on the bottom of the storage drive.
Figure 82. Installing the storage drive into the bracket
1 , pin
.
Chapter 7 Hardware removal and installation
2 , pin 3 , and pin
5
101