What To Do If - AEG S92500CNM0 User Manual

14 www.aeg.com

WHAT TO DO IF...

WARNING!
Before troubleshooting, discon-
nect the mains plug from the
mains socket.
Only a qualified electrician or
competent person must do the
troubleshooting that is not in this
manual.
Problem
The appliance is noisy The appliance is not sup-
The appliance does
not operate.
The buzzer sounds.
The Alarm light flash-
ing.
The compressor op-
erates continually.
The compressor does
not start immediately
after pressing the
FROSTMATIC button,
or after changing the
temperature.
Possible cause
ported properly
The appliance is switched
off.
The mains plug is not con-
nected to the mains sock-
et correctly.
The appliance has no
power. There is no voltage
in the mains socket.
The temperature in the
freezer is too high.
The temperature is not set
correctly.
The door is not closed cor-
rectly.
The door has been
opened too frequently.
The product temperature
is too high.
The room temperature is
too high.
This is normal, no error has
occurred.
Products prevent that wa-
ter flows into the water
collector.
Solution
Check if the appliance
stands stable (all the four
feet should be on the floor)
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
Connect a different electri-
cal appliance to the mains
socket.
Contact a qualified electri-
cian.
Refer to "High Tempera-
ture Alarm".
Set a higher temperature.
Refer to "Closing the
door".
Do not keep the door open
longer than necessary.
Let the product tempera-
ture decrease to room tem-
perature before storage.
Decrease the room temper-
ature.
The compressor starts after
a period of time.
Make sure that products do
not touch the rear plate.