Thermoplan Black&White3 Installation, Initial Start-Up, Safety page 4

Installation and putting into operation
Important indications
•
GENERAL
•
SAFETY NOTES
•
•
•
•
Only an instructed service-engineer may install the unit. The manufacturer is not liable for injuries caused by an improper mountig
INSTALLATION AND
of the unit.
POSITIONING
•
•
•
•
•
•
•
Risk of fire!
The machine is to be installed in noncombustible surroundings only, with nocombustible material within 50 cm (18 inches) of
the sides, front or rear of the machine and within 100 cm (40 inches) above the machine.
The appliance is to be mounted on floors of noncombustible construction with noncombustible flooring and surface finish.
•
ELECTRICAL
•
CONNECTIONS
•
•
•
•
•
Risk of fire and electric shock!
Replace only with Thermoplan's cord set (for details see spare parts list in the Thermoplan Online Shop).
© 2015 by Thermoplan AG, Subject to change
Technical Manual
In case of an emergency, immediately remove the plug from the power socket.
The hot water tube, steam, hot water and coffee are very hot. Avoid direct contact with the skin (danger of burning /
scalding)!
Remove the plug from the mains socket if you will not be using the machine for an extended time (holidays).
Also close the water connection under the drip tray.
Do not use the machine if it is not operating perfectly or if is shows any sign of damage.
Do not put any objects on the machine.
Shocks to the machine and its components must be avoided.
The machine has to be installed on a solid, level and heat-resistant base.
The unit may not have a direct contact to the customer. The only exception are automated coffee machines which are made
for self-service use.
The machine must be free standing for optimal ventilation.
Do not install the machine in a warm or humid location.
The surrounding temperature must be between 16 °C (60 °F) and 32 °C (90 °F).
The machine is made for indoor use only.
Never place the machine on a hot surface, e.g. a heating plate. Never use it around an open flame.
The power supplies have to correspond with the rating plate.
This appliance is electrically safe only when properly grounded as set forth in the current electric safety specifications. Check
for compliance and, when in doubt, have the wiring thorougly inspected by skilled personnel. The manufacturers shall not
be liable for any damage caused by faulty grounding.
Using adapters, multiple plugs and cable extensions are not recommended. Should they be indispensable, use simple or
multiple adapters and extensions that comply with the current safety regulations, take care not to exceed the limit current
load shown on simple adapters and extensions, and the limit power load shown on multiple adapters.
When the unit is permantly connected to a field terminal, a disconnect switch must be installed at the field terminal. The
disconnect switch shall disconnect all lines from power net, except grounding.
To prevent dangerous overheating, uncoil the power cord to its full length.
When the power cord or plug is damaged, you may not use the machine. In order to avoid danger, have the defective part
repaired or replaced by a service technician.
Never leave the power cord near or in contact with hot parts of the machine, a source of heat, or a sharp edge.
CAUTION
CAUTION
REV-5
SECTION 2
2.4