Mellanox Technologies SX6720 Hardware User Manual page 37

Table 11 - Configuration Wizard Session
Rev 2.0
Wizard Session Display
Step 4: Enable IPv6 auto-con-
fig (SLAAC) on mgmt0 inter-
face? [no]
Step 5: Enable DHCPv6 on
mgmt0 interface? [no]
Step 6: Admin password (Press
<Enter> to leave unchanged)?
<new_password>
Step 6: Confirm admin pass-
word? <new_password>
You have entered the following
information:
<A summary of the configura-
tion is now displayed.>
To change an answer, enter the
step number to return to or hit
<enter> to save changes and
exit.
Choice: <Enter>
Configuration changes saved.
Mellanox Technologies
Comments
This turns on auto-configuration of the IPv6 addresses. This is
unsuitable for DHCPv6.
To enable DHCPv6 on the MGMT0 interface.
To avoid illegal access to the machine, please type a password
and then press <Enter>. Then confirm the password by re-enter-
ing it.
Note that password characters are not printed.
The wizard displays a summary of your choices and then asks
you to confirm the choices or to re-edit them.
Either press <Enter> to save changes and exit, or enter the con-
figuration step number that you wish to return to.
Note:
To re-run the configuration wizard, run the command "configura-
tion jump-start" in Config mode.
Installation
37