Page 1
Nest x Yale Lock Installation and Programming Guide Warning Status Settings Indicator Speaker Back button Check (Set / Continue) Low Battery Indicator Failsafe 9 volt Battery Connection (Use Alkaline battery) Keypad Before you begin DOWNLOAD Deadbolt THE BILT APP Strike Plate...
Page 2
Template 2-3/4" [70mm] Backset For 1-3/4" [44.5mm] Thick Door 1" 2-1/8" [25mm] [54mm] Dia. Thru Hole 2-1/8" 1" [54mm] [25mm] CAUTION: Dia. Thru Hole If printed from electronic file set print s cale to For 1-3/8" Measure ruler to check scale [35mm] 2"...
Page 3
Before you begin, open door and remove your existing deadbolt. Before you begin, double check your door prep measurements. 2-3/8" or 2-3/4" (60mm or 70mm) Backset 2-1/8" (54mm) Door Prep Diameter Template 5-1/2" (140mm) Standard Check clearance with lower hardware if this dimension is less than 5-1/2"...
Page 4
Installing Deadbolt 2-3/4" (70mm) 2-3/8" (60mm) Position Position Mechanism Pull (Horizontal Orientation) 2-3/8" (60mm) Backset Press 2-3/4" (70mm) Backset Bolt must be in retracted (unlocked) position. Mechanism will be horizontal. Note UP arrow on deadbolt. 2-3/8" (60mm) or 2-3/4" (70mm) Installing Strike Plate Frame Choose...
Page 5
Installing Keypad Bolt must be in retracted (unlocked) position. Note horizontal orientation of mechanism. Inside of Door Outside of Door Installing Interior Mounting Plate Make sure plate and keypad are level before tightening through bolts. Choose through bolt appropriate for your door Inside of Door thickness.
Removing Battery Cover 000XXX XXXX0 000000 Attaching the Cable Make sure to connect cable with black mark side up. Secure cable in hooks. AYRD -540-INST-FUL Rev 4...
Installing Inside Lock 000XXX XXXX0 000000 Make sure bolt is retracted. Make sure inside lock is properly seated onto bottom of mounting plate and excess cable is tucked into lock cavity. Testing Operation 000X XX XXX X000 0000 Close door and check bolt operation.