Subaru BRZ 2018 Owner's Manual page 330

3-5. Other interior features
Using HomeLink
To operate, simply press and release the programmed HomeLink but-
ton. Activation will now occur for the trained device (i.e. garage door
opener, gate operator, security system, entry door lock, home/office
lighting, etc.). For convenience, the handheld remote of the device
may also be used at any time.
Reprogramming a Single HomeLink Button
To program a previously trained button, follow these steps:
Press and hold the desired HomeLink button. DO NOT
STEP 1
release the button.
The indicator light will begin to slowly flash orange after 20
STEP 2
seconds. The HomeLink button can be released at this point.
Proceed with "Programming a New HomeLink Button" -
STEP 3
If you do not complete the programming of a new device to
STEP 3
the button, it will revert to the previously stored programming.
Erasing HomeLink Buttons
To erase programming from the three buttons (individual buttons can-
not be erased but can be "reprogrammed" as outlined below), follow
the step noted:
Press and hold the two outer HomeLink buttons for at least 10 sec-
onds. The LED indicator will change from continuously lit to rapidly
flashing. Release both buttons. Do not hold for longer than 20 sec-
onds. HomeLink is now ready to be programmed at any time begin-
ning with "Programming a New HomeLink Button" -
328
.
.
STEP 1