Subaru BRZ 2018 Owner's Manual page 273

■
CFRP (Carbon Fiber Reinforced Plastic) parts
●
Due to the properties of the carbon fiber used in CFRP parts, the shade
and density of the carbon fiber weave may vary.
●
Cleaning and protecting the CFRP parts:
WARNING
■
After adjusting the angle of the rear wing
Make sure that the bolts and nuts are tightened securely. If they are not, the
rear wing may come off while driving, possibly leading to an accident.
CAUTION
■
Handling of the rear wing
●
Do not push or pull the rear wing with excessive force. Doing so may dam-
age the rear wing.
●
When waxing the vehicle, be careful not to leave any residual wax
between the wing and wing end-plates.
■
When adjusting the angle of the rear wing
Observe the following precautions. Otherwise, the rear wing may be dam-
aged.
●
Make sure to loosen the rear nuts and bolts before adjusting the angle of
the rear wing.
●
When installing the rear bolts, make sure that both the left and right bolts
are installed to the same position for the desired angle.
●
Do not loosen the nuts and bolts on the front side.
2-4. Using other driving systems
P. 337, 338
2
271