Subaru BRZ 2018 Owner's Manual page 329

STEP 8
■
Gate Operator / Canadian Programming
Canadian radio-frequency laws require transmitter remote signals
to "time-out" (or quit) after several seconds of transmission, which
may not be long enough for HomeLink to pick up the signal during
programming. Similar to this Canadian law, some U.S. gate opera-
tors are designed to "time-out" in the same manner. The indicator
LED on the hand-held remote will go off when the device times out,
indicating that it has finished transmitting.
If you live in Canada or you are having difficulties programming a
gate operator or garage door opener by using the programming
procedures, replace "Programming a New HomeLink Button"
with the following:
STEP 3
While the HomeLink indicator light is flashing orange, press and
release ("cycle") your device's hand-held remote every two sec-
onds until the HomeLink indicator light changes from orange to
green. You may now release the hand-held remote button.
If programming a garage door opener or gate operator, it is advised to
unplug the device during the "cycling" process to prevent possible over-
heating.
Proceed with "Programming a New HomeLink Button"
plete.
3-5. Other interior features
If status indicator arrows appear
next to the indicator light, please
refer to "Garage Door Two-Way
Communication". ( P. 329)
In the event that there are still
programming difficulties or ques-
tions, additional HomeLink infor-
mation and programming videos
can be
www.HomeLink.com
www.youtube.com/HomeLink-
Gentex. For Genie and Sommer
garage door openers please go
directly to the HomeLink website.
found at
and
STEP 4 to com-
327
3