References - Huawei AR530 Series Configuration Manual

Huawei AR530&AR550 Series Industrial Switch Routers
Configuration Guide - Reliability
Common Causes
After BFD session parameters are modified, the configuration is not committed.
Procedure
Step 1 Run the display current-configuration configuration bfd-session command to check the BFD
session configuration and check whether the commit command is used.
l If the commit command is used, the modified BFD parameters are committed.
l If the commit command is not used, the modified BFD parameters are not committed. Run
----End

5.10 References

This section lists references of BFD.
The following table lists the references of this document.
Document
RFC 5880
RFC 5881
RFC 5882
RFC 5883
RFC 5884
Issue 01 (2014-11-30)
NOTE
Saving the results of each troubleshooting step is recommended. If your troubleshooting fails to correct
the fault, you will have a record of your actions to provide Huawei technical support personnel.
the commit command to commit the configuration.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Description
Bidirectional Forwarding
Detection (BFD)
Bidirectional Forwarding
Detection (BFD) for IPv4
and IPv6 (Single Hop)
Generic Application of
Bidirectional Forwarding
Detection (BFD)
Bidirectional Forwarding
Detection (BFD) for
Multihop Paths
Bidirectional Forwarding
Detection (BFD) for MPLS
Label Switched Paths (LSPs)
5 BFD Configuration
Remarks
-
-
-
-
-
149