Opening Lists With The Message Key - Gigaset S450 User Manual

Gigaset S455 / USA EN / A31008-M1714-B101-1-19 / direct_charges.fm / 28.3.06
S450
Using the directory and lists
Opening lists with the
message key
The message key will illuminate after each
missed call whether the caller left a voice
mail message or not. You can use the mes-
sage key f to open the following lists:
u
Network mailbox
If your network provider supports this
function and the network mailbox is
configured for fast access (page 20).
u
Calls list
An advisory tone sounds as soon as a new
entry appears on a list. The f key
flashes (it will go off when the key is
pressed). In idle status, the display shows
an icon for the new message.
Icon New message...
Ã
... in network mailbox
Á
... in calls list
The number of new entries is shown
beneath the corresponding icon.
Only the lists that contain messages are
shown (exception: network mailbox). Lists
with new messages are shown first and
identified in bold. The number of new or
old messages contained are each shown
in brackets.
Select the list with q. To open, press
18
Calls list
Requirement: Caller ID Presentation (CIP,
page 11)
Depending on the type of list set, the calls
list contains
u
accepted calls (
u
missed calls (e.g. [3] means: 3rd caller)
The numbers of the last 30 incoming calls
are stored.
Multiple missed calls from the same
number are only stored once (the last
call).
Setting list type for calls list
¢ ¢
v Ð
Missed Calls /
Select and press
a
Press and hold (idle status).
The entries in the calls list are retained
when you change the list type.
.
§OK§
‰
)
¢
Base Calls List Type
All Calls
‰
(
§OK§
= on).