Omron CJ1W-PRT21 Operation Manual page 8

Introduction
Section
Section 8
Other Units
Section 9
Troubleshooting
Appendices
CS/CJ-Series PROFIBUS Master Units Operation Manual (Cat. No.
W409)
Section
Section 1
Features and Specifications
Section 2
Installation and Wiring
Section 3
Configuration Software
Section 4
Allocated CIO and DM Words
Section 5
FINS Commands and Responses
Section 6
Operation
Section 7
Troubleshooting and Maintenance
Appendix
6
This section provides the basic specifications for the other Units used in Slice I/O ter-
minals.
This section describes error processing and troubleshooting procedures needed to
keep the Slice I/O Units operating properly.
The appendices describe the following:
Explicit Messages
Standard Models
Power Consumption and Weight Tables
I/O Current Consumption Table
Precautions When Connecting Two-wire DC Sensors
This section provides an introductory overview of PROFIBUS, its functions and how
to setup and configure a network. It also addresses the PROFIBUS Master Units and
the configurator, their features and specifications.
This section shows the PROFIBUS device and identifies its controls and indicators. It
contains the procedures for installing the CS1/CJ1W-PRM21 PROFIBUS Master Unit
and configuring the PROFIBUS network.
This section contains the procedures for installing the configuration software. It also
presents an overview of the Configuration software and discusses the main aspects
of defining a PROFIBUS configuration.
This section describes the words allocated to the CS1/CJ1W-PRM21 PROFIBUS
Master Unit in the CIO and DM Areas.
This section describes the FINS message service communications commands con-
cept as well as the commands supported by the CS1/CJ1W-PRM21 PROFIBUS
Master Units.
This section describes how to operate the CS1/CJ1W-PRM21 PROFIBUS Master
Unit in a Network. It will discuss setting up a network, configuring all the connected
devices and starting the network. Furthermore, it provides information the I/O data
exchange performance and it also provides information on how to monitor a network
using the Unit and CX-ConfiguratorFDT.
This section describes the troubleshooting procedures and maintenance operations
for the CS1/CJ1W-PRM21, needed to keep the PROFIBUS network optimally work-
ing.
The appendices describe the following:
Bus Parameters
Slave Diagnostics
I/O Data Conversions
Configuration Error and Warning Messages
Memory Card Backup Functions
Application Notes
C200HW-PRM21 Notes
CJ-series PROFIBUS Slave Unit Operation Manual for NJ-series CPU Unit (W510)
Description
Description