Set Water Hardness - BWT AQA perla Installation And Operating Manual

Any Sanitary Any Sanitary
Any Sanitary Any Sanitary Any Sanitary
0815 1234567 0815 1234567
0815 1234567 0815 1234567 0815 1234567
22 22 22 22 22
0 0 0 0 0
Sodium content Sodium content Sodium content
Sodium content Sodium content
Increase by 180 mg/l Increase by 180 mg/l Increase by 180 mg/l
Increase by 180 mg/l Increase by 180 mg/l
20 20 20
20 20
6 6 6 6 6

Set water hardness

Set water hardness Set water hardness Set water hardness Set water hardness
The drinking water hardness as measured on the
spot and the desired blended water hardness
(residual hardness) must be entered here.
The raising of the sodium content is displayed in
accordance with the hardness setting.
IN IN IN IN IN Drinking water hardness
Enter hardness reading for drinking water.
Correct figures
Confirm
OUT OUT OUT OUT OUT Blended water hardness
Enter desired blended water hardness (residual
hardness). (BWT recommendation 4° - 8° dH. In
Austria a residual hardness of > 8.4 °dH is
prescribed).
Confirm
GB GB GB GB GB
1 3 1 3 1 3 1 3 1 3
1 3 1 3 1 3
1 3 1 3