Connect The Label Printer To A Computer; Connect Using A Usb Cable; Connect Using Wi-Fi - Brother QL-1110NWB User Manual

Print Using a Computer (P-touch Editor)

Connect the Label Printer to a Computer

Refer to these directions for the type or connection method:
 USB Cable connection
See Connect Using a USB Cable on page 10.
 Wireless LAN connection
See Connect Using Wi-Fi
 Wired LAN connection
See Connect Using a Wired LAN on page 14.
 Bluetooth Connection
See Bluetooth Connection on page 14.

Connect Using a USB Cable

a
Make sure the Label Printer is turned Off before connecting the USB Cable.
b
Connect the USB Cable to the USB Port on the back of the Label Printer, and then to your computer.
c
Turn the Label Printer On.

Connect Using Wi-Fi

The following Wi-Fi connection methods are available:
 Infrastructure Mode
 Wireless Direct
 WPS (Wi-Fi Protected Setup™)
Infrastructure Mode
Infrastructure Mode allows you to connect the Label Printer to a computer via a Wi-Fi access point/router.
 Before You Begin
First, you must configure the Wi-Fi settings of the Label Printer to communicate with your Wi-Fi access
point/router. After the Label Printer is configured, computers on your network will have access to the Label
Printer.
®
on page 10.
®
2
2
2
2
2
10