Specifications; Operation - Porter-Cable PT501 Instruction Manual

Maximum Torque
Blows Per Minute
Free Speed RPM @ 90 PSI
Maximum Working Pressure
Air Inlet
Recommended Hose Size
Air Consumption @ 90 PSI
Accessories Required
Line pressure or hose inside diameter should be increased to compensate for
IMPORTANT:
unusually long air hoses (over 25 feet). Minimum hose diameter should be 3/8" I.D. and
fittings should have 1/4" NPT thread.

Operation

Before each use:
G
Drain water from air compressor tank and condensation from air lines. See air
compressor's operators manual.
G
Lubricate tool, see "Maintenance" section in this manual.
G
Select the required impact socket. This tool has a 1/2" square drive, use 1/2" deep
sockets. Use 1/2" extensions only when needed.
G
Connect tool to air hose of recommended size. NOTE: The use of a quick connect
set makes connecting easier. See the "Accessories" section of this manual.
IMPORTANT: The use of air filters and air line lubricators is recommended.
To use:
G
Turn air compressor on and allow air tank to fill.
G
Set the air compressor's regulator to 90 PSI. This tool operates at a maximum 90
PSI pressure.
G
Set torque regulator, see chart, to set the desired setting to avoid over tightening.
IMPORTANT: These torque values can
vary depending on the size of the air
compressor and the cubic feet of air
(SCFM) the air compressor delivers.

SPECIFICATIONS

OPERATION
Disconnect the tool from the air supply before lubricating or
changing sockets.
Impact wrench sockets and accessories must be used with
this tool. Do not use hand sockets and accessories.
400 ft./lbs.
1000
7000
90 PSI
1/4" NPT
3/8" I.D.
4.2 SCFM
ASSEMBLY
Line up desired torque # with raised pin
#1 approximately 190-250 ft./lbs. Torque
#2 approximately 250-300 ft./lbs. Torque
#3 approximately 300-350 ft./lbs. Torque
#4 approximately 350-400 ft./lbs. Torque
5- ENG
D22725