Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
Base Units
fig 1
fig 2
fig 3
fig 5
fig 7
1
WWW.UTOPIAGROUP .COM
page 6
Flush Pipe
Waste Pipe
fig 4
fig 6
fig 8
2
WC FASCIA CUT OUTS
When fitting a WC it may be necessary to cut the bottom fascia to accommodate both the
soil pipe and flush pipe. Use the pottery as a template (see fig 1, 4 and 5).
NOTE: Wall-hung WC pottery should not be screwed directly to the fascias as the WC
units are not load carrying.
Wall-hung pottery needs a steel supporting frame which has two large bolts that need to
be accommodated within the fascia panel. The plinth must also be cut to accommodate
the soil pipe (see fig 2) if applicable.
You may have to remove one of the rear legs of this unit to accommodate the waste pipe.
For aesthetic looks a pan return should be used to act as a filler between the front of the
plinth (if applicable) and the back of the WC pan (see fig 3). To ensure a good fit, screw
through the back of the plinth into the pan return (see fig 6).
Re-seal all cut edges.
UTOPIA PUSH BUTTON CONCEALED CISTERNS
The concealed cistern for use in Utopia Furniture is pneumatically operated by a small push
button which is both aesthetically pleasing and functional.
The cistern unit complies with the new regulations, maximum 6 litres flush volume, and is
totally installer and user friendly.
DUAL FLUSH PUSH BUTTON CISTERN FEATURES
1.
190 x 100mm clip-off service panel.
2.
Complete with push-fit water inlet pipe and internal isolation valve
WC PANELS
These panels are held in place by your wall-hung or back-to-wall
toilet pan.
Additional fixings can be hidden behind the push button plate if
required (see fig 8).
(see fig 7)
.
Hide quick links:
Advertisement
Table of Contents
