Solid Surface And Laminate Worktops - Utopia Lustre series Installation Instructions Manual

Solid Surface and Laminate Worktops

PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE COMMENCING WORK
All Solid Surface tops are packed together with a relevant fitting pack and are identified by a label which appears on the front of the box and the
rear of the packaging.
It is advised that fitting commences from a corner wherever possible, ensuring correct spacing should a corner filler be used.
It is also advised that all doors and facias are removed prior to fitting to avoid unnecessary damage occurring.
If the Worktop has become slightly bowed during storage it can be pulled straight during the installation process.
GUIDE FOR THE INSTALLATION OF SOLID SURFACE PRODUCTS
IMPORTANT
These instructions must be followed when installing Solid Surface Products.
We recommend that you use the following tools:
Portable router - To do all cuts and cross cuts wherever possible.
Orbital Sander - for finishing rough or cut edges.
We DO NOT recommend that you use the following:
Jigsaw - Do all cuts and cross cuts with a router wherever possible.
However, a jigsaw may be used only if a brand new downward cutting blade is used and these instructions are strictly adhered to.
WWW.UTOPIAGROUP .COM
Belt Sander - for finishing rough or cut edges.
Hole Saw - for cutting out tap holes
Spade and Auger type drill bits - Always use hole saws.
page 37