Table of Contents
Advertisement
Base Units
C
A
B
fig 1
fig 3
Plinth can be fitted to the rear legs
fig 5
fig 6
WWW.UTOPIAGROUP .COM
ADJUSTING A SOFT CLOSE DRAWER BOX
Drawer boxes are factory installed and should not need to be adjusted. However, if
adjustment is required, pull the drawer box out and remove the Utopia branded plastic
cover cap. This will reveal the two adjustment screws. Use one of the screws to raise and
lower the drawer box (see fig 1 A) and the other (see fig 1 B) to move it, left and right.
Large drawer units have a fixing bracket, located in the centre of the drawer box on the
fig 2
underside, that needs to be slackened off before adjustment and re-tightened after.
If you need to remove a drawer box, lift up and away from the drawer runners.
To replace the drawer box, fully extend the drawer runners, place the drawer box onto
them and close the drawer. The box will clip itself in to place upon closing (see fig 2).
To remove drawer front from the side turn screw (see fig 1 C).
FITTING A PLINTH
Cut the plinth to the required length. If you are using a Plinth Return to go around a 90°
corner, reduce the overall length by 20mm to accommodate the corner piece.
On the reverse of the plinth mark the position of the cabinet legs in order to fix the leg
plates and cups. Fix with number 6 x 5/8 screws.
Push the plinth complete with clips onto the legs (see fig 3).
Alternatively;
As another option to wall hanging or fitting the plinth on the front legs of the cabinet, you
can remove the front legs and the plinth may be fitted to the rear legs only, (see fig 4).
fig 4
Please Note
Before fitting always check that you have identified the correct finish side of the plinth.
Plinth Returns can be used to take a plinth round an internal (see fig 4) or an external (see
fig 5) corner.
page 5
Hide quick links:
Advertisement
Table of Contents
