Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
Worktops
fig 1
Fascia
fig 2
Correct position - Cowl is seated centrally
a
Incorrect position - Cowl is not seated centrally
a
fig 3
fig 4
WWW.UTOPIAGROUP .COM
page 40
FITTING A SOLID SURFACE APRON STANDARD
AND SHORT PROJECTION
Position the fascia into the slot ensuring that the fascia is tight against the front edge of the
slot.
Ensure that the apron remains central on the fascia,
top edge of the apron sits above the top edge of the fascia (a) is equal on both sides
(see fig 2)
.
Apply a bead of good quality silicone to the top edge of the apron.
Align the fixings on the fascia with the fixings on the cabinet and push the fascia onto the
cabinet until it locks into place.
Apply a small amount of upwards pressure to the apron until it fits flat against the underside
of the worktop and temporarily stick it in place using several pieces of masking tape
(see fig 3).
Wipe off any excess silicone with a clean cloth.
We recommend that you leave the silicone a minimum of 12 hours to set before removing
a
the masking tape.
SOLID SURFACE SHELVES AND SHELF SUPPORTS
1
Firstly, ensure that the small adjustment bolt remains seated in the back of the bracket
before fixing (see fig 4).
2
Mark the positions of the bracket holes on the wall, relative to the size of the shelf.
Take care to ensure the holes are level with each other using a spirit level. Drill into
the wall at the marked points. Insert the rawlplugs or other appropriate fixing.
a
3
Check that the nut and bolt are loosely in position in the back of the bracket
(see fig 4), and screw the brackets to the wall (see fig 5).
4
When both brackets are securely fixed place the shelf centrally between the clasps
and turn the adjustment screws on the underneath of the brackets until the shelf is
securely held in place (see fig 6).
fig 5
(see fig 1)
, and the distance that the
fig 6
Hide quick links:
Advertisement
Table of Contents
