Definity Fitted Bath - Utopia Lustre series Installation Instructions Manual

Definity Bath Panels
fig 1
TOP VIEW OF DEFINITY BATH
WALL
PANELS FITTED INTO A CORNER
E
fig 2
TOP VIEW OF DEFINITY BATH
PANELS FITTED INTO A RECESS
WALL
E
fig 3
TOP RAIL OPTIONS CUT TO SIZE ON
INSTALLATION AT POINTS A & B
CUTOUT FOR OVERFLOW
A
WWW.UTOPIAGROUP .COM
page 28
WALL
D
F
WALL
D
F
B
POSITION THE BATH TO ALLOW
AN EQUAL DISTANCE AROUND
THE BATH RIM AND TOP RAIL
DEFINITY FITTED BATH - CORNER OR RECESSED
INSTALLATION
Remove all protective film from panels before fixing together. Note in some
instances the pre-drilled holes will be covered by the panels finish. These
holes will need to be reinstated.
END
PANEL
NOTE when fitting a top rail this is to be done first. See top rail notes
below, (see fig 3, and 4)
C
Level the bath to ensure the panels will not have to be cut to the floor when
they are installed.
The side panel set of three parts D, E & F are held together with the cams
and bolts provided. Panels D & E have two magnetic catch plates to be
fixed at the top in the pre-marked positions. The black Keku clips are for
extra support and are fitted at each end where the panels meet the end
(see fig 1)
panel
away from the edge as panels E and D are also used with return panels as
(see fig 1)
shown in
Fix the end return panel as shown
provided. The three side panels will then push into place.
(see fig 2)
, also see notes on page 29.
WALL
fig 4
TOP RAIL OPTIONS CUT TO SIZE ON
INSTALLATION AT POINTS A & B
A
(see fig 2)
or a wall . The pre-marked positions are set
.
(see fig 1)
using the stretcher plates
CUTOUT FOR OVERFLOW CUTOUT FOR OVERFLOW
POSITION THE BATH TO ALLOW
AN EQUAL DISTANCE AROUND
THE BATH RIM AND TOP RAIL
B