Downton - Utopia Lustre series Installation Instructions Manual

Downton

This range of furniture is supplied assembled and can be placed in position for installation to
start. Any electrical work must be completed by a qualified electrician. Mirror transformers
could be set into the wall plaster behind the mirror, or in the recess on top of the unit
keeping it to the back.
Should the plinth panels supplied be required, by turning the unit upside down these can
be screwed into the back of the unit legs.
The wall and mirror units will be fitted using the wall hanging fittings found behind the back
(See page 8. & 11)
panel. . Tall units and intermediate high units are also fitted with wall
hangers. When a fixed back is fitted to a cupboard a stabilising screw into the wall near the
base which will ensure the unit stays tight against the wall.
In some floorstanding units a stretcher plate can be used to support the unit sides, also a
See fig 4, page 3).
fixing through the back top rail into the wall. (
Worktops are held with stretcher plates or silicone, locate the top position and fix as
needed. Solid surface tops with an under slung ceramic basin have a supporting shelf which
See fig 1-7, page 27).
will need to be levelled and fixed. (
(See page 5)
Drawer box removing and adjusting. .
(See page 9)
Door removing and adjusting. .
Bath panels come complete should the plinth panels supplied be required these can be
screwed to the back of each panel before panels are fitted. End panels can be fixed with
(see page 29)
stretcher plates .
Bath side panel can be pushed into place using keku clips (see fig 3, page 29).
WWW.UTOPIAGROUP .COM
page 26