Utopia Opula Installation Manual

Installation Guide
Opula 800mm Vanity Unit
Important Information
•
Read the instructions carefully.
•
Check the product for any signs of damage and remove any protective film.
•
It is recommended that this product is fitted by a suitably qualified Part P registered
electrician in accordance with current IET & Building Regulations.
•
It is the installer's responsibility to carry out a thorough assessment of wall type and the
weight of the cabinet and use appropriate fixings.
•
Care should be taken when drilling walls to avoid any hidden wires or pipes.
•
To prevent the cabinet falling down this product must be fixed using the wall attachment
device provided.
•
The light source in this luminaire is not replaceable. When the light source reaches its
end of life, the whole luminaire must be replaced.
•
This product should be used only with a mains supply that is protected by a 30mA
Residual Current Device.
•
This product is IP20 Rated and is only suitable for installation in Outside Zones in a
bathroom. It is not suitable to be fitted in zones 0, 1 or 2.
WARNING
RISK OF ELECTRIC SHOCK
Turn off Mains Electric prior to commencing work.
Connection to Mains Electrics
Turn off the electrical supply.
Connect the mains lead from the drawer lights to the electrical supply in the bathroom. It is
recommended that this lead is connected to a constant electrical feed.
Connect the mains lead from the under-cabinet lights to the electrical supply in the bathroom. It is
recommended that this lead is connected to the bathroom light circuit or a room sensor.
Turn the electrical supply back on and check that the lights function as required.