Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
i-Line Wall and Frameless Mirror Unit
fig 1
fig 2
A
A
fig 3
i-Line Modular Units
WWW.UTOPIAGROUP .COM
page 22
see also
fig 2a below
D
C
B
FITTING WALL UNITS
See page 9 of these instructions.
FITTING AN i-LINE FRAMELESS MIRROR UNIT
The frameless mirror is held onto the backboard with an integrated 50mm side panel with
two keyhole grommets. Remove the mirror by carefully lifting it up and away from the back-
board and put to one side.
Put the Backboard into position and fix to the wall using appropriate fixings, (see fig 1).
Replace the mirror onto the backboard before fixing the 50mm flyover panel.
Screw the 50mm side panel near the front through the top and bottom panels using 3"
screws and cover caps (supplied), (see fig 2) and (see fig 2A).
FITTING SUGGESTION
To help fitting we suggest that you fit i-Line wall configurations in the following order:
1. Wall units and 50mm side panel (see fig 3 A).
2. 50mm i-Line shelf that runs under the units (see fig 3 B).
3. i-Line mirror unit with 50mm side panel (see fig 3 C).
4. 50mm i-Line flyover that runs over the units (see fig 3 D).
50mm mirror
side panel
fig 2a
screw position
25mm
front edge
I-LINE MODULAR UNITS
See page 14 for the fitting of wall hung modular units.
Twin units will need to be screwed together. The 50mm x 100mm base rail is screwed from
the under side of the units with the 2 ½" screws supplied. Use the 1 ¼" screws to fix into
the 50mm side panels. The 1" screws are to screw the two units together. All screws can
now be capped. FIx the worktop in the usual manner.
Hide quick links:
Advertisement
Table of Contents
