Quantum rdx8000 Quick Start Manual page 6

POWER UP AND ASSIGN IP ADDRESS
Power Up
In standby mode, the power indicator glows solid amber. To power up,
press the power switch on the front. The indicator will flash green for
about 2 minutes while the RDX 8000 boots up. Once the boot sequence is
complete, the indicator glows solid green and the display panel will
show the unit's status.
To power down the RDX 8000, press and hold the power switch for
4 seconds, then release it. The indicator will flash amber until the
unit is in standby mode, when it will glow solid amber.
Assign IP Address
The RDX 8000 is configured to communicate over Ethernet Port 1,
and will search for an IP address as follows:
1. After powering up, it will search your local network for a
DHCP server.
2. If a DHCP server is found, it will assign an IP address to the
RDX 8000; this address will appear on the display panel.
3. If no DHCP server is found after 60 seconds, the RDX 8000
will assign a static IP address, which will then appear on
the display panel.
4. Once an IP address is assigned, you may use RDX 8000 RMI
to reconfigure the unit to a new static IP address or redirect it
to a DHCP server.
5