Troubleshooting - Angelcare AC017 Owner's Manual

Movement monitor
Hide thumbs Also See for AC017:
Table of Contents

Advertisement

TROUBLESHOOTING

FALSE ALARMS
• Turn OFF the Nursery Unit.
• Make sure there is no bedding between the mattress and the Sensor Pad.
• If the cot has a spring or slat base, place a hardboard between the crib base and the
Sensor Pad measuring at least 33 x 33 cm and 6 mm thick.
• Make sure Sensor Pad is positioned as described under the setup requirements. Sensitivity may need to
be adjusted (refer to Step 4.3).
• Re-connect the Sensor Pad and Nursery Unit by pressing and holding the Nursery Unit Pairing button for
2 seconds until the blue light flashes and you hear a beep.
ALARM WILL NOT SOUND
• Avoid contact with the cot when the monitor is ON.
• Place cot near a solid supporting wall to avoid Sensor Pad from detecting movement
from outside the cot.
• Turn OFF cot mobile, fans, loud music or anything else that may cause vibration.
• You may need to decrease the sensitivity (refer to Step 4.3).
SENSOR PAD LIGHT INDICATOR FLASHING RED
• Make sure there is no bedding between the mattress and the Sensor Pad.
• The Sensor Pad must rest on a completely flat and firm surface. If the cot has a spring or slat base, place
a hard board between the cot base and the Sensor Pad measuring at least 33 x 33 cm and 6 mm thick.
• Make sure Sensor Pad is positioned as described under the setup requirements. Sensitivity may need to
be adjusted (refer to Step 4.3).
LOSS OF CONNECTIVITY (NURSERY UNIT BLUE LIGHT FLASHES AND
EMITS A BEEP EVERY 20 SECONDS)
• Bring the units closer together.
• Press and hold for 2 seconds the Nursery Unit Pairing button, the Nursery Unit will emit a beep and will
flash blue to confirm connectivity.
NO POWER
• Check or replace batteries.
• Make sure monitor is ON.
Power ON/OFF Light Indicator
Low Battery Light Indicator
Flashing green
Flashing yellow
Nursery Unit batteries are low
Sensor Pad Light Indicator
No movement is detected or
Flashing red
Sensor Pad lost connectivity
Flashing white
Flashing yellow
Sensor Pad battery is low
Monitor is activated
Monitor is paused
E
N
7

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AC017 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents

Save PDF