NCA-1611 User Manual
NCA-1611 is built with one 2.5" HDD/SSD slot drive bay as well as the support for SATADOM. The following
will discuss disk drive installation procedures based on their designs.
1. Locate the 2.5" disk bay area in the
chassis.
2. Loosen the screws that secure the
empty HDD tray.
3. Insert the four rubber washers into
the four notches of the tray.
4. Install the disk into the tray and
secure it with the provided disk
screws.
Make
sure
connector faces outwards as shown
in the picture.
the
SATA
31
Align and push the
washer
3
into the notch.
4
2
horizontally
SATA
Contacts