Pyle PLCD19XMR Owner's Manual page 9

INSTALLATION
INSTALLATION HARDWARE
HOLDER
X1
INSTALLATION DIAGRAM
3. Align the screw holes on the holder with
the screw holes on the base and the
screw holes on the bracket, then use the
two screws (ø4X50) and nuts to fix the
bracket, the base and holder to the proper
location.
4. Last install the remote control to the
holder. See below, align the four hooks
on the holder with the four slots on the
remote control.
SCREW (ø4X50)
X2
1. First insert the hooks on the base into
2. Select the proper object, then place the
BASE
X1
NUT
the slots of the holder to install the base
to the holder.
remote mounting bracket on the base
and let the object go through the base
and the mounting bracket.
9
REMOTE
MOUNTING BRACKET
X1
X2
WIRE