Compatibility With Z-Wave Gateways (Hubs) - QUBINO Flush 2 relay User Manual

6. Compatibility with Z-Wave Gateways (hubs)

Please check compatibility with your Z-Wave gateway (hub) before you purchase this device. If
you don't see your gateway (hub) in the table below, please contact us at:
http://qubino.com/support/#email.
ⓘ
Please note that the gateway (hub) compatibility was tested on 1.7.2017 and it may not
include the latest testing data.
Flush 2 Relay Q1+Q2
with gateway
(hub)
✓
Domoticz
V3.5877
✓
Fibaro HC Lite
v 4.100
✓
Zipato 1.1.38
✓
Vera edge v
1.7.2406
✓
Z-Wave me
✓
Homeseer
3.0.0.313
✓
Open Z-Wave
✓
Piper
SmartThings O
3rd party
✓
NETIChome
Homey T
✓
Eedomus
✓
Jeedom
Q1 Q2 W
Measurements
✓ ✓ ✓
✓ ✓ ✓
✓ ✓ ✓
✓ ✓ ✓
✓ ✓ ✓
✓ ✓ ✓
✓ ✓ ✓
✕ ✕ ✕
✓ ✓
O
✓ ✓ ✓
T T T
✓ ✓ ✓
✓ ✓
O
Symbol
✓
✕
O
T
kWh Temperature
Measurements Measurements
✕ ✓
✓ ✓
✕ ✓
✓ ✓
✓ ✓
✕ ✓
✓ ✓
✕ ✕
✓ ✓
✓ ✓
T
✓ ✓
✓
Explanation
Works fully
Not working
See comment
Testing in progress
20
EN.
Comments
When excluding the device, after
using this handler, the device needs
to be excluded via long reset.
Additional sensor handlers need to
be installed.
T
The measure of consumption is not
O
automatic, we need to actived the
pooling (configuration: Values and
refresh)