Cisco ASR 5500 System Administration Manual page 276

VPN-Related CLI Commands
CLI Mode
MPLS-IP Configuration Mode
MPLS-LDP Configuration Mode
MPLS-LDP Configuration Mode
MPLS-LDP Configuration Mode
MPLS-LDP Configuration Mode
MPLS-LDP Configuration Mode
Table 18: VPN-Related Monitoring Commands
CLI Mode
Exec Mode show Commands
Exec Mode show Commands
Exec Mode show Commands
Exec Mode show Commands
Exec Mode show Commands
ASR 5500 System Administration Guide, StarOS Release 21.5
250
Command
protocol ldp
advertise-labels { explicit-null |
implicit-null }
discovery { hello { hello-interval
seconds | hold-interval seconds }
| transport-address ip_address }
enable
router-id ip_address
session timers { hold-interval
seconds | keepalive-interval
seconds }
Command
show ip bgp neighbors
show ip bgp vpnv4 { all |
route-distinguisher | vrf }
show ip bgp vpnv6
show ip bgp vpnv6 { all |
route-distinguisher | vrf }
show ip pool
BGP MPLS VPNs
Description
Creates the MPLS protocol family
configuration modes, or configures
an existing protocol and enters the
MPLS-LDP Configuration Mode
in the current context. This
command configures the protocol
parameters for the MPLS protocol
family.
Configure advertisement of Implicit
NULL or Explicit NULL label for
all the prefixes advertised by the
system in this context.
Configures the Label Distribution
Protocol (LDP) neighbor discovery
parameters.
Enables Label Distribution Protocol
(LDP).
Configures the LDP Router ID.
Configures the LDP session
parameters.
Description
Displays information regarding
BGP neighbors.
Displays all VPNv4 routing data,
routing data for a VRF or a
route-distinguisher.
Displays contents of VPNv6
routing table.
Displays all VPNv6 routing data,
routing data for a VRF or a
route-distinguisher.
Displays pool details including the
configured VRF.