Configurable Bgp Route Advertisement Interval For Icsr; Bgp Cli Configuration Commands - Cisco ASR 5500 System Administration Manual

Configurable BGP Route Advertisement Interval for ICSR

from deploying BGP Prefix Independent Convergence (PIC) in the Optical Transport Network Generation
Next (OTNGN).
BGP PIC is intended to improve network convergence which will safely allow for setting aggressive ICSR
failure detection timers.
configure
context context_name
service-redundancy-protocol
]
Notes:
• hold-off-time hold-off-time delays advertising the BGP routes until the timer expires. Specify hold-off-time
• After resetting BFD, reset-bfd-nbrs bfd-down-time keeps the BFD sessions down for the configured
Configurable BGP Route Advertisement Interval for ICSR
By default, the MinRtAdvInterval is set for each peer with a value of 5 seconds for an iBGP peer and 30
seconds for an eBGP peer. An operator can use the neighbor identifier advertisement-interval command to
globally change the default interval.
The BGP advertisement-interval can also be separately set for each address family. If configured, this value
over-rides the peer's default advertisement-interval for that address-family only. BGP will send route
update-message for each AFI/SAFI based on the advertisement-interval configured for that AFI/SAFI. If no
AFI/SAFI advertisement-interval is configured, the peer-based default advertisement-interval is used.
In ICSR configurations, this feature can be used to speed route advertisements and improve network
convergence times.
The timers bgp icsr-aggr-advertisement-interval command is available in both the BGP Address-Family
(VPNv4/VPNv6) Configuration and BGP Address-Family (VRF) Configuration modes.
configure
context context_name
router bgp as_number
Notes:
• seconds – sets the number of seconds as an integer from 0 to 30. Default: 0.

BGP CLI Configuration Commands

The following table lists the BGP Configuration mode CLI commands that support the configuration of various
BGP parameters. For additional information, refer to the BGP Configuration Mode Commands chapter of the
Command Line Interface Reference
ASR 5500 System Administration Guide, StarOS Release 21.5
220
advertise-routes-in-standby-state [ hold-off-time hold-off-time ] [ reset-bfd-nbrs bfd-down-time
end
in seconds as an integer from 1 to 300.
number of milliseconds to improve network convergence. Specify bfd-down-time as an integer from 50
to 120000.
address-family { ipv4 | ipv6 | vpnv4 | vpnv6 }
timers bgp icsr-aggr-advertisement-interval seconds
Routing