Cisco ASR 5500 System Administration Manual page 266

VLAN-Related CLI Commands
CLI Mode
Ethernet Interface Configuration Mode
Ethernet Port Configuration Mode
PVC Configuration Mode
Subscriber Configuration Mode
VLAN Configuration Mode
VLAN Configuration Mode
VLAN Configuration Mode
VLAN Configuration Mode
VLAN Configuration Mode
Table 16: VLAN-Related Monitoring Commands
CLI Mode
Exec Mode show commands
Exec Mode show commands
Exec Mode show commands
ASR 5500 System Administration Guide, StarOS Release 21.5
240
Command
vlan-map next-hop ipv4_address
vlan vlan_id
[no] shutdown
ip vlan vlan_id
bind interface interface_name
context_name
[no] ingress-mode
priority value
[no] shutdown
vlan-map interface if_name
context_name
Command
clear port slot/port vlan vlan_id
show logical-port utilization table vlan
{ 5-minute | hourly }
show port info slot/port vlan vlan_id
Description
Sets a single next-hop IP address so that
multiple VLANs can use a single next-hop
gateway. The vlan-map is associated with
a specific interface.
Enters VLAN Configuration mode.
Enables or disables traffic over a specified
VLAN. See below.
Configures the subscriber VLAN ID that is
used with the assigned address for the
subscriber session to receive packets. If the
IP pool from which the address is assigned
is configured with a VLAN ID, this
subscriber configured VLAN ID overrides
it.
Binds a virtual interface and context to
support VLAN service.
Enables or disables port ingress incoming)
mode.
Configures an 802.1p VLAN priority bit
for ASN-GW service only.
Enables or disables traffic over the current
VLAN.
Associates an IP interface having a VLAN
ID with a context.
Description
Clears NPU statistics for the port that has
a previously configured VLAN ID.
Displays VLAN utilization for a specified
collection interval.
Displays NPU counters for a previously
configured VLAN ID.
VLANs