Dedicated Transmission Parameters; Programming Procedure - Ricoh B082 Service Manual

Hide thumbs Also See for B082:

Table of Contents

DEDICATED TRANSMISSION PARAMETERS

3.4 DEDICATED TRANSMISSION PARAMETERS

Each Quick Dial Key and Speed Dial Code has eight bytes of programmable

parameters allocated to it. If transmissions to a particular machine often experience

problems, store that terminal's fax number as a Quick Dial or Speed Dial, and

adjust the parameters allocated to that number.

The programming procedure will be explained first. Then, the eight bytes will be

1. Set the bit 0 of System Bit Switch 00 to 1.

2. Press "Dest. Management" in the facsimile standby mode.

3. Press "Program/Change/Delete Quick Dial".

4. Select the destination key you want to program.

5. When the programmed dial number is

displayed, press "Start".

Make sure that the LED of the Start

button is lit as green.

6. The settings for the switch 01 are now

displayed. Press the bit number that

you wish to change.

7. To scroll through the parameter

switches, either:

8. Select the next switch: press "Next"

Select the previous switch: "Prev." until the correct switch is displayed.

Then go back to step 6.

9. After the setting is changed, press "OK".

10. After finishing, reset bit 0 of System Bit Switch 00 to 0.

B547S901.WMF

B547S902.WMF

Table of Contents